Well i've been to do this long time ago , but always witout time to do it, but , i managed to get this as a school project and so here it is the final result with lot's of pictures of all the Work progress and the Bay in action
THe Start !!
The used LCD ->240 x 128 with T6963C Controler
The front part of the Bya being adjusted
http://pwp.netcabo.pt/samtech/mods/lcd_bay/imag0101.jpg
The acrilic base for the LCD Bay
View of the LCD bay and it's metalic base
The first LCD tests and from the base and rest of the ilumination
The ilumination test from the Acrilic base
The LCD Test
The board wiith the ilumination conectors, the inverter conector and the LCD conector:
More ilumination test's
The sides of the bay , the acrilic molding ans the painting.
The acrilic base after all ajustment's ,holes and some edge polishing:
The sides before adjustment
The sides after adjustment and polishing
A very goo hair dryer from Black&Decker with 2000W
to mold the acrilic (Aka heat gun)
The acrilic for the back cover after molding, and preparing to finish up the sides
The sides and back cover after finished and polished:
THe painting of the metalic base, the sides (Tha were painted on the inside , so we can get a miror finish ) and the front of the bay:
To place the acrilic on the bay there were 2 ideas , but othe firs on gave some bad result's due to a chemical reaction between the acrilic , the paint and a paste used to fill in the space, so i opted by polishing the front acrilic as the other part's and the result was much better then i expected
And what all we where wainting for , the final result !!
Left , right and front view of the bay
back view
The Bay in action
It's content's after all conected:
My WOrk Bench
Well that's all , hope you to enjoy it as much as i do
Samtech
Portugal RULA !!!!
Modding PT By SAmtech