320x240 with SED1335 controller problem
Page 1 of 1

Author:  Couger [ Sun Aug 07, 2005 20:15 ]
Post subject:  320x240 with SED1335 controller problem

Hi all

Ive got one of Henri's 320x240 displays and so far untill earlier im well happy with it

Ive got a big problem with the display, all was working fine with the
display untill earlier when i was in the config section of the driver and ive
tryed everything to get the display wotking again, all im getting is lines
accross the screen, ive even tryed default install of lcdinfo but nothing im
worried that ive damaged the controller chip any, do my settings look right


Thanks for anyones help in advance


Author:  mingingbollock [ Sun Aug 07, 2005 22:11 ]
Post subject: 

Try with a freq of 10mhz and your res is at 128x64 should be 320x240 , and check your wiring ,
mine is wired for the info preset , which is different to your wiring above.
Hope you get it going again :D

Author:  Couger [ Mon Aug 08, 2005 0:17 ]
Post subject: 

all done and working it was the XTAL needed setting to 10 mhz

heres some pics of the display and frame i got for it



Cheers Cougs

Page 1 of 1 All times are UTC + 2 hours
Powered by phpBB® Forum Software © phpBB Group