Hello and sorry if this is noob questions!I have bought a USB controller from Henri.The thing is im unsure where to connect the wires from the controller to the display.
Also its backlit,I have an inverter,But on the controller board i have a 4 pin connector with the lable backlight.Do i need to connect the display to this output or is it for another type of display?
Do i need knobs to adjust contrast and brightness or is that overkill?
It was alon time since i connected my old display so i consider myself as a noob
If someone could help me i would be very happy!Want it up and running asap
----------------------------------------------------------
Pin-out Toshiba Display 640*200 pixels
* 1: GND
* 2: 50 Hz
* 3: FRAME GND
* 4: Line
* 5: Data Shift (Pixel Strobe)
* 6: Logical Ground
* 7: Data 3
* 8: Data 2
* 9: Data 1
* 10: Data 0
* 11: Logical GND
* 12: +5V
* 13: -17 - 19V
* 14: -21V (Contrast)
* 15: GND
------------------------------------------------------------
Controller board
1 FPFRAME First line marker
2 FPLINE Data latch
3 GND Ground (0V)
4 FPSHIFT Data shift
5 FPD0 Display data
6 FPD1 Display data
7 FPD2 Display data
8 FPD3 Display data
9 GND Ground (0V)
10 GND Ground (0V)
11 +5V Power supply (+5V)
12 +5V Power supply (+5V)
13 MOD Alternate (M / MOD / WF) (Note 1)
14 /DISPOFF Display On / Off (Note 1)
15 VEE Power supply for LCD drive
16 VADJ LCD contrast adjust voltage
17 +3.3V Power supply (+3.3V) (Note 1)
18 NC Not connected
19 +12V Power supply (+12V)
20 +12V Power supply (+12V)
As i said im unsure where to connect the pins to eachother
.
Login
FAQ
Search
