LCDInfo.com

http://www.lcdinfo.com
It is currently Thu Mar 28, 2024 10:55

All times are UTC + 2 hours




Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Sat Nov 07, 2009 22:47 
Offline

Joined: Sun May 05, 2002 22:05
Posts: 2063
Location: Lappeenranta, Finland
Markus sent me these pictures of a Planar EL.640.200 SK display modded in his case and being driven by USB13700 controller board. Looks good to me :)

Image
(click picture for a larger version)

Image
(click picture for a larger version)

Image

Image


Top
 Profile  
 
 Post subject:
PostPosted: Sat Nov 07, 2009 22:54 
Offline

Joined: Sun May 05, 2002 22:05
Posts: 2063
Location: Lappeenranta, Finland
Couple days ago I also drew this schematic example how to connect a EL.640.200 SK to the USB13700 board:
http://www.lcdinfo.com/usb13700/misc/US ... .200SK.pdf

To my knowledge nobody has yet built a cable using this as a reference so please double check everything yourself in case there are any mistakes. My suggestion when doing the wiring is to connect as many ground wires between the display and the controller board as possible and keep the ground wires close to the signal wires.


Top
 Profile  
 
 Post subject:
PostPosted: Sun Nov 08, 2009 12:26 
Offline

Joined: Sun Nov 08, 2009 12:18
Posts: 5
Hi,

the shematics are right, but i prefer to get the power direct from the power supply and not from your board.
with conector 24 and a 100kohm poti against gnd it is possible to dimm the display and prevent burn ins. you can see the pot knop on my pictures below the front-usb conector.

thanks again henri for your great support and this great little board!

markus


Top
 Profile  
 
 Post subject:
PostPosted: Sat Dec 19, 2009 20:00 
Offline

Joined: Tue Jun 17, 2008 15:40
Posts: 35
Henri wrote:
To my knowledge nobody has yet built a cable using this as a reference so please double check everything yourself in case there are any mistakes. My suggestion when doing the wiring is to connect as many ground wires between the display and the controller board as possible and keep the ground wires close to the signal wires.


Hello Henri
I wired up my EL 640.200 and it works perfekt, thanks for the schematics. :D
My conector 24 is also conected with a "poti",thanks mash.m for the Tip.

Edit:
Detail connected Potentiometer
Image

Some more Pictures are HERE


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 13 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group