LCDInfo.com

http://www.lcdinfo.com
It is currently Thu Jun 22, 2017 16:17

All times are UTC + 2 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Thu Jan 26, 2012 11:33 
Offline

Joined: Thu Jan 26, 2012 11:28
Posts: 1
Hi everyone,

I've posted this question in the ETO forum but not getting a good response there... So I wanted to opt here. So here goes:

1. I've setup my Nokia 6100 LCD, read the datasheet and some tutorials by Jim Lynch (Sparkfun) with some improvisations. I built the circuit using just a perfboard, and hopefully got it all right.

The only thing is, the example programs are a bit harder for me to understand, since they use libraries. I only want to test the LCD and see if my setup is working, so I need a code to just light it up. I can, however, write bare C programs without libraries.

So basically, here's how I connected everything:
1. RC5 (SDO) to SDI of the LCD,
2. RC3 (SCK) to SCK of the LCD,
3. RB2 (PORTB) to RESET
4. RB3 (PORTB) to CS

I shifted the voltage output of the PIC using diodes to around 3.9V (The max rating, I believe is 4.0V from what I read in the datasheet)

Also, I used an LM7808 (8V output) to power the lighting.

So, can anyone guide me to a simple, library-free test MikroC program? I've fossicked everywhere for it, no avail though.

2. There's also another thing. I tested the output of the PIC's toggling output (to simulate a SCK and SDO signal) at 1ms interval. After the signal goes through two voltage-dropping diodes, the output is like this:

Image

I wonder if it affects the performance of the LCD?


Thanks for the time spent on this guys.

Vizier87.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group