Try Henri
he may post to Oz
| LCDInfo.com http://forum.lcdinfo.com/ |
|
| Where to get sed133* controllers http://forum.lcdinfo.com/viewtopic.php?f=6&t=1392 |
Page 1 of 1 |
| Author: | penjuin [ Tue Oct 25, 2005 10:05 ] |
| Post subject: | Where to get sed133* controllers |
I have recently had to turn down an opportunity to get a Planar EL640x200 display, purely because it had no controller, and I could not find where to get one. Does anyone know where these can be bought? I'm hoping that coorz knows, seeing as he has a 640x200. Mouser has discontinued them. Any help would be appreciated. -penjuin |
|
| Author: | mingingbollock [ Tue Oct 25, 2005 10:32 ] |
| Post subject: | |
Try Henri he may post to Oz
|
|
| Author: | coorz [ Tue Oct 25, 2005 15:37 ] |
| Post subject: | |
Mine's runs on a SED board (with a hacked up a FFC cable) from Henri indeed. I also have a board from MPI (USA), but that one isn't build too well. |
|
| Author: | HumanBan [ Wed Oct 26, 2005 1:15 ] |
| Post subject: | |
You can buy SED1335's from www.futurlec.com.au. They have them listed in Components\Integrated Circuits\Special Function\Other for AU$19.28: http://www.futurlec.com.au/test13.jsp?c ... u=ICOTHERS For anyone in the US, they also have www.futurlec.com for American customers which I imagine would stock it also. I've bought from the Australian site before and found them to be quite good, if a little slow in delivering |
|
| Author: | coorz [ Wed Oct 26, 2005 10:19 ] |
| Post subject: | |
Yes that's just the chip. To build a complete controller you'll need more components and design and etch your own PCB. |
|
| Author: | penjuin [ Wed Oct 26, 2005 11:09 ] |
| Post subject: | |
Is there any components other then caps, resistors, xtals etc that are needed? |
|
| Author: | coorz [ Wed Oct 26, 2005 11:26 ] |
| Post subject: | |
Here's a site with a SED scheme. For Planars you can omit the DC converter ofcourse. Also you need to plan how to interface the Planar to the SED board; by means of which connectors that is. http://www.lamepage.de/hardware/gfxlcd/index_de.html |
|
| Author: | penjuin [ Wed Oct 26, 2005 13:13 ] |
| Post subject: | |
Lets say I did manage to get hold of an EL640x200 planar display. Approx how much would it cost to get a board and hack cables to get it working with lcdinfo and/or lcdstudio? |
|
| Author: | coorz [ Wed Oct 26, 2005 13:26 ] |
| Post subject: | |
Well it has to be the 640.200 SK version. A SED board you can ask Henri. In my case i hacked up a FFC cable because i didn't want to hack up the SED board, you can also solder the SED>Planar connection if you're up to it. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|