| LCDInfo.com http://forum.lcdinfo.com/ |
|
| How to connect HD61202 to an AVR908515 ? http://forum.lcdinfo.com/viewtopic.php?f=6&t=183 |
Page 1 of 1 |
| Author: | Dasti [ Tue Mar 25, 2003 22:48 ] |
| Post subject: | How to connect HD61202 to an AVR908515 ? |
Hi everybody? Does someone have a ready ciruit to connect a HD61202 display to my AVR? I'm a beginner and don't know how to do this? Cause of Power Supply of -8V etc. THX Sorry for my bad english! |
|
| Author: | Henri [ Wed Mar 26, 2003 13:55 ] |
| Post subject: | |
Do you have a datasheet for the display ? Some information about the display pinout and voltage requirements are needed to give more specific information. But basically you need to connect the D0-D7 pins to one port of the AVR and CS, EN, DI, (RW, RESET) pins to other AVR port. And then the voltages of course. |
|
| Author: | Dasti [ Thu Mar 27, 2003 22:46 ] |
| Post subject: | thx |
thx i have it! |
|
| Author: | blogic [ Fri Mar 28, 2003 21:36 ] |
| Post subject: | ks0108 hd6*** |
i am working on a project to connect a glcd to a 8515 i wired d0-d7 to protc and e cs1 cs2 rs to pora.4-7 the code is almost finished bitmaps are supported iam working on the font atm i will post the code here in a day or two the way i did the wiring was to make the cable that lcdinfo uses and then add a female 25pin to may circuit that way you can use the display for both b-logic 
|
|
| Author: | Henri [ Sun Mar 30, 2003 1:21 ] |
| Post subject: | |
b-logic: That sounds very interesting. I'm waiting to see what you have done... |
|
| Author: | darko [ Fri Oct 29, 2004 13:02 ] |
| Post subject: | Re: ks0108 hd6*** |
blogic wrote: i am working on a project to connect a glcd to a 8515
i wired d0-d7 to protc and e cs1 cs2 rs to pora.4-7 the code is almost finished bitmaps are supported iam working on the font atm i will post the code here in a day or two the way i did the wiring was to make the cable that lcdinfo uses and then add a female 25pin to may circuit that way you can use the display for both b-logic Do you have finished project? I'm interesting in seeing code for AVR that controls graphic display, because I have already made it for character display ... Darko |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|