| LCDInfo.com http://forum.lcdinfo.com/ |
|
| 16x1 VFD Display http://forum.lcdinfo.com/viewtopic.php?f=6&t=2259 |
Page 1 of 1 |
| Author: | AceVonWildfire [ Thu Jun 21, 2007 2:27 ] |
| Post subject: | 16x1 VFD Display |
Hey ya'll... in my recent attempt to clean up my apartment... I dug up a "Futaba Corp. Of America" US16SY11AB 16x1 VFD display. According to the datasheet (found here: http://www.datasheet4u.com/html/U/S/1/U ... A.pdf.html)... it has a synchronous serial connection (SCLK/DATA). It runs off of +5V... so powering it is not an issue... but I'm curious to find out how one would rig this to the computer. Ideas? Ace Von Wildfire |
|
| Author: | AceVonWildfire [ Sat Jun 30, 2007 7:25 ] |
| Post subject: | |
Anyone? I could really use some help with this. Ace Von Wildfire |
|
| Author: | cex [ Sat Jun 30, 2007 16:56 ] |
| Post subject: | Serial interface |
Hello, take a look at the post called "interfacing a Sony-Ericsson t68 LCD". I posted a HW I/F and some sample code. The T68 LCD uses an I2C protocol, but it is implemented enterely in SW, so the HW I/F is valid for you. You will only have to change the program for the protocol and commands of your LCD. Hope this helps. |
|
| Author: | cex [ Sat Jun 30, 2007 16:59 ] |
| Post subject: | Power Supply |
Sorry, I forgot thet your LCD runs from 5V supply. You will have to adjust the regulator for that voltage, but the idea is still valid. Regards. |
|
| Author: | AceVonWildfire [ Wed Jul 04, 2007 18:30 ] |
| Post subject: | |
Thanks for your help. Ace Von Wildfire |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|