| LCDInfo.com http://forum.lcdinfo.com/ |
|
| Problem with KS0108 http://forum.lcdinfo.com/viewtopic.php?f=6&t=241 |
Page 1 of 1 |
| Author: | faramc [ Mon May 12, 2003 16:23 ] |
| Post subject: | Problem with KS0108 |
I have a big Problem with my KS0108-LCD. When I start LCDInfo, for a second, the LCD works, but then just the left part of the Screen is shown. On the right side there's nothing. I've tried the test-programm for the Controller, everthing is good until I load a bitmap, then just the left side is shown... Can anybody help me? |
|
| Author: | askmike [ Fri Jun 06, 2003 17:44 ] |
| Post subject: | RE: Problems with the KS0108 |
I had the same problem with my display and i just switched the pins on the display wich control cs1 and cs2, on my diplay pin 12 and 13. |
|
| Author: | mob_zamani [ Mon Jun 27, 2005 4:51 ] |
| Post subject: | Re: Problem with KS0108 |
faramc wrote: I have a big Problem with my KS0108-LCD.
When I start LCDInfo, for a second, the LCD works, but then just the left part of the Screen is shown. On the right side there's nothing. I've tried the test-programm for the Controller, everthing is good until I load a bitmap, then just the left side is shown... Can anybody help me? |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|