| LCDInfo.com http://forum.lcdinfo.com/ |
|
| NT7703 NT7704 drivers with RA8835a (SED1335 and S1D13305)? http://forum.lcdinfo.com/viewtopic.php?f=6&t=2672 |
Page 1 of 1 |
| Author: | pogorman [ Fri May 22, 2009 22:48 ] |
| Post subject: | NT7703 NT7704 drivers with RA8835a (SED1335 and S1D13305)? |
Hi, Does anyone know if the LCD controller RA8835a (SED1335 and S1D13305 equiv) can be used with the following LCD drivers, NT7704 & NT7703? http://www.optrex.com/products/partdeta ... NF-SLY-ALN I want to use the Optrex display above and I am familiar with the RA8835. I am wondering if the two are compatible? Unfortunately this Oprex LCD is the only one that meets my specification, except for the fact it doesn't have a in-built controller. It only has a 4bit interface and NT7704 & NT7703 drivers. I am very familiar with the RA8835a fro, other projects and would like to stick with it. However controller-less LCDs are something new to me so I don't know what controller I can use with LCD. Any input is welcome. Thanks, Philip |
|
| Author: | pogorman [ Tue May 26, 2009 0:59 ] |
| Post subject: | |
To answer my own question, here is what RIAO sent me: "The RA8835A controller can be used with LCD drivers NT7704 & NT7703. Those drivers have 4 bit parallel input modes that's compatible to 4 bit drver data outputs of RA8835." |
|
| Author: | Henri [ Sat Jun 06, 2009 17:54 ] |
| Post subject: | |
True. That display should be compatible with the common 4-bit driving scheme as supported by S1D13305, RA8835 and S1D13700 for example. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|