| LCDInfo.com http://forum.lcdinfo.com/ |
|
| USB to Parallel http://forum.lcdinfo.com/viewtopic.php?f=6&t=279 |
Page 1 of 1 |
| Author: | Kenneth [ Mon Jul 07, 2003 17:01 ] |
| Post subject: | USB to Parallel |
Hello everybody, I'm from HongKong. I've recently bought a Turly 128x64 Graphic LCD and found out that is controlled by KS1080. I can get correct display on a Dell Pentium III computer at my office. However if I hook the display on my computer at home (Epox 8RDA+), the display content is broken. Is it possible to connect my display to a USB-LPT adaptor for printer? http://www.bafo.com/bafo/productslists. ... uct_id=832 |
|
| Author: | Henri [ Mon Jul 07, 2003 20:01 ] |
| Post subject: | |
Usually this isn't possible. Some chips used in these converters would allow this if I understood the datasheets right but often the drivers don't. So you would probably have to write your own drivers for it. I don't personally have much experience with these converters but I don't remember anyone succesfully running lcd's with usb-lpt converters. If you are lucky the converter from the link might work but I don't think your chances are very good. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|