LCDInfo.com

http://www.lcdinfo.com
It is currently Fri Mar 29, 2024 16:53

All times are UTC + 2 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Tue Sep 02, 2003 17:56 
I measured that some of my parallal output pins have less than 5 volt. For example the D0-D7 have only 3.3 Volt in the high state. But the control pins have 4.5V or even 5 V. Did anybody experience problems due this low voltages? Can I change that to the full five volts?
I blew up one of my LCDs but do not know why. Thanks for your help.


Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 38 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group