LCDInfo.com

http://www.lcdinfo.com
It is currently Fri Aug 14, 2020 1:50

All times are UTC + 2 hours




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Thu Feb 19, 2004 13:00 
Offline

Joined: Thu Feb 19, 2004 12:51
Posts: 2
Hello there!

I have a problem with my LCD:

I wired it like described in 64128A_ver2.pdf from this page. This should be OK, also the solder connections are alright...
The parallel port is on ECP/EPP, like suggested...
I'm using the display with VCC=+5V...

When I turn the display on, sometimes there's nothing to see, sometimes there are black stripes and areas!? The ks0108-Test-Program and LCD-Info v0.3.2 doesn't work...

Can someone help me please?

Robert


Top
 Profile  
 
 Post subject:
PostPosted: Fri Feb 20, 2004 20:11 
Offline

Joined: Sun May 05, 2002 22:05
Posts: 2063
Location: Lappeenranta, Finland
I remember seeing black stripes with 64128A when the timing was bad. But this was with the first LCDInfo 0.3 versions with KS0108 support when I didn't yet have my own KS0108 display to test.

You should check that all your connections go where they should.

You could also try without the 10K pullup resistors. Personally I've never used those.


Top
 Profile  
 
 Post subject:
PostPosted: Sat Feb 21, 2004 23:59 
Offline

Joined: Mon Jan 06, 2003 20:53
Posts: 3
Location: Germany - Leipzig
The ECP+EEP-mode doesn't work with my (same) LCD. Try to check out the normal mode on on parallel port.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group