LCDInfo.com • View topic - flickering output at all after startup lcdinfo

View unanswered posts | View active topics

Board index » General display discussion » Hardware

All times are UTC + 2 hours

flickering output at all after startup lcdinfo

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

Karel

Post subject: flickering output at all after startup lcdinfo

Posted: Sat May 08, 2004 15:52

Joined: Mon Apr 12, 2004 9:43
Posts: 3

hi,
I tried a new display today and is a mgls24128-HT-G with a hd61830 controller.
I wired it and with power on all the pixels light up but after I start the lcdinfo the whole screen flickers in a strange sequence. The same happens with liquid mp3. The power is according to the datasheet but I can't seem to find the problem. Does someone have an idea how to debug this thing?

Top

Henri

Post subject:

Posted: Wed May 12, 2004 22:57

Joined: Sun May 05, 2002 22:05
Posts: 2063
Location: Lappeenranta, Finland

I think you should check your wiring. And also make sure you have the wiring config in LCDInfo set correctly. HD61830 flickers when it's not yet properly initialized.

Top

Page 1 of 1

[ 2 posts ]

Board index » General display discussion » Hardware

All times are UTC + 2 hours

Who is online

Users browsing this forum: No registered users and 47 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum