Hi, this is my first post here so be gentle k
.
I'm looking for the method in which to connect an LCD panel I have, it is branded SHARP LM24012 & has 1x HD61203S & 3x HD61200S the display is a graphics display whith a viewable area of 45x198mm approx.
The spec sheet is easily found for this IC but I do not have a clue as to how to go about connecting it to either the serial or parallel port on a PC which is what I would like to do with it. I do have HD44780's and have no problems with them but this 1 has me tossed
as I am unfarmiliar with some of the terminology used on some of the pinouts and have little to do with serial interface, I say that as there is no bus D0-D7 lines with which to work with on the main IC HD61203S.
I have had the display going and filled the screen with dots but that was only by applying power and adjusting the pot but thats it.
The PDF can be downloaded from here:-
http://www.data-modul.de/de/service/dow ... 61203U.pdf
It says it is a HD61203U but it is the same as the HD61203S so far as I can tell. It's the first package in the PDF file.
If pictures are needed I can email them no problems.
Any help would be appreciated greatly and if more info is needed please ask.
Thanks in advance Prolater