This is the pinout from an ATX connector.
I hope it answers your question.
Found it on: http://forums.overclockers.com.au/ in modding & electronics thread and there the: OCAU Official LCD and Case Modding FAQ.
| LCDInfo.com http://forum.lcdinfo.com/ |
|
| ATX test supply http://forum.lcdinfo.com/viewtopic.php?f=8&t=817 |
Page 1 of 1 |
| Author: | BubbaFrag [ Sun Sep 05, 2004 5:56 ] |
| Post subject: | ATX test supply |
greetings. i'm trying to use an ATX power supply out of an old Gateway for testing purposes, just to have some voltages available. my understanding is that - at the MB power connector - all you have to do it short the green wire (pin 14, /PS_ON) to any black wire and the supply should turn on. when i do this the supply starts up for a second, then shuts down. any help would be appreciated. thx, Bubba. |
|
| Author: | P@CKiE [ Mon Sep 06, 2004 7:02 ] |
| Post subject: | |
|
This is the pinout from an ATX connector. I hope it answers your question. Found it on: http://forums.overclockers.com.au/ in modding & electronics thread and there the: OCAU Official LCD and Case Modding FAQ. |
|
| Author: | coorz [ Mon Sep 06, 2004 7:32 ] |
| Post subject: | |
The PSU needs a load to stay on; so connect a fan or two or anything that draws current, then try again. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|