LCDInfo.com

http://www.lcdinfo.com
It is currently Mon Nov 25, 2024 12:12

View unanswered posts | View active topics


Board index » General display discussion » Other

All times are UTC + 2 hours




Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Print view Previous topic | Next topic 
Author Message
BubbaFrag
 Post subject: ATX test supply
PostPosted: Sun Sep 05, 2004 5:56 
Offline

Joined: Sat Sep 04, 2004 21:43
Posts: 2
Location: New Haven County, Connecticut
greetings.

i'm trying to use an ATX power supply out of an old Gateway for testing purposes, just to have some voltages available.

my understanding is that - at the MB power connector - all you have to do it short the green wire (pin 14, /PS_ON) to any black wire and the supply should turn on. when i do this the supply starts up for a second, then shuts down.

any help would be appreciated.

thx,
Bubba.
Top
 Profile  
 
P@CKiE
 Post subject:
PostPosted: Mon Sep 06, 2004 7:02 
Offline

Joined: Fri Sep 03, 2004 14:59
Posts: 7
Location: The Netherlands
Image

This is the pinout from an ATX connector.
I hope it answers your question.
Found it on: http://forums.overclockers.com.au/ in modding & electronics thread and there the: OCAU Official LCD and Case Modding FAQ.
Top
 Profile  
 
coorz
 Post subject:
PostPosted: Mon Sep 06, 2004 7:32 
Offline
User avatar

Joined: Sat Apr 17, 2004 17:42
Posts: 467
Location: The Netherlands
The PSU needs a load to stay on; so connect a fan or two or anything that draws current, then try again.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » General display discussion » Other

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group