LCDInfo.com

http://www.lcdinfo.com
It is currently Tue Apr 16, 2024 8:08

View unanswered posts | View active topics


Board index » General display discussion » Development

All times are UTC + 2 hours




Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
Zee
 Post subject: Initializing SED1335
PostPosted: Wed Aug 03, 2005 20:33 
Offline

Joined: Wed Aug 03, 2005 20:27
Posts: 130
Location: .fi
Sorry for using binary but at the moment I'm using a port testing software to command this 320x240 blue/white panel (the one Henri sells).

01000000*
00111000
10000111
00000111
00100111
01000010
11101111
11110000
00000000

That's the main init function I'm using. When executing after powerup the screen stabilizes but after that I can't get anything else to happen. The screen just stays white.

I think the TC/R value is ok as the screen starts "scrolling" again if it's too low of too high.

I'm not so sure about the other values. The SED1335 datasheet is somewhat cryptic in few areas. :)
Top
 Profile  
 
rennie606
 Post subject: hi
PostPosted: Fri Dec 30, 2005 14:14 
Offline

Joined: Fri Dec 30, 2005 14:08
Posts: 4
Location: india
If you are still interested to have the answer reply back, 'coz ur query is toooooooooo old.
Regards
rennie606
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » General display discussion » Development

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 14 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group