LCDInfo.com • View topic - Using the T6963C LCD controller?

View unanswered posts | View active topics

Board index » General display discussion » Development

All times are UTC + 2 hours

Using the T6963C LCD controller?

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

snj_lcduser

Post subject: Using the T6963C LCD controller?

Posted: Mon Jul 24, 2006 22:36

Joined: Mon Jul 24, 2006 22:01
Posts: 2

Hello,

I am just starting to program with the pic p18f4480, and T6963C controller to display text/graphics on an LCD unit. The LCD is 128x128, and I am using the Microchip C18 compiler.

I was hoping to find some examples on the internet based in the C18 (c) language, which could help me start sending commands/data to the LCD.

I understand from the T6963c data sheet the command and data will be written as a byte. And before every read/write to the toshiba controller the status must be checked.

I wondered if anyone had any examples in the C18, c language which I could use as a start point?

Thank you

Top

Henri

Post subject:

Posted: Wed Jul 26, 2006 18:13

Joined: Sun May 05, 2002 22:05
Posts: 2063
Location: Lappeenranta, Finland

It's not C18 but at least it's C code for microcontroller:
http://forum.lcdinfo.com/viewtopic.php?t=362

Maybe that could help you a bit.

Top

Page 1 of 1

[ 2 posts ]

Board index » General display discussion » Development

All times are UTC + 2 hours

Who is online

Users browsing this forum: No registered users and 71 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum