LCDInfo.com http://forum.lcdinfo.com/ |
|
Optrex F-51900 interfacing with Epson S1D13706 http://forum.lcdinfo.com/viewtopic.php?f=9&t=2226 |
Page 1 of 1 |
Author: | OMGthatsCraZY [ Fri May 11, 2007 0:09 ] |
Post subject: | Optrex F-51900 interfacing with Epson S1D13706 |
Hey, Im trying to interface the Epson S1D13706 LCD controller with the Optrex F-51900 LCD but Im having a bit of trouble with it. Which generic bus design outlined in the LCD controller datasheet should I use for the interface? I believe its the Generic bus design #2 but Im not sure. Also, the F-51900 claims to do more than 256 colors but in its datasheet is only accepts 3 bits (R, G, B) for each pixel....how does it accomodate 256 or more colors? Here are the datasheets: http://www.optrex.com/SiteImages/PartLi ... -FW-AC.pdf http://www.erd.epson.com/index.php?opti ... &Itemid=40 Any help would be appreciated....first time doing this kind of development. -J |
Author: | Myscha [ Sat Mar 29, 2008 2:08 ] |
Post subject: | Re: Optrex F-51900 interfacing with Epson S1D13706 |
OMGthatsCraZY wrote: Im trying to interface the Epson S1D13706 LCD controller with the Optrex F-51900 LCD but Im having a bit of trouble with it. Which generic bus design outlined in the LCD controller datasheet should I use for the interface? I believe its the Generic bus design #2 but Im not sure. Are you talking about the interface between S1D and LCD? If you do, Generic #2 Bus wouldn't be correct, because it's for 9-bit LCD. You should have a look at Figure 3-8. OMGthatsCraZY wrote: Also, the F-51900 claims to do more than 256 colors but in its datasheet is only accepts 3 bits (R, G, B) for each pixel....how does it accomodate 256 or more colors?
Where did you read this? I think it is really only RGB, that means 3 colors... |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |