LCDInfo.com

http://www.lcdinfo.com
It is currently Fri Mar 29, 2024 15:20

All times are UTC + 2 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Wed May 14, 2003 19:23 
Offline

Joined: Wed May 14, 2003 19:08
Posts: 1
Hi all,
I connected a T6963C based display (240X64) to a National COP8 microcontroller. I am writing the software but I found some problem:

- I try to inizialize the controller then I write some data to the graphic memory but I get nothing on the display
- Every command or data I write I have to wait a long long time before the status bits STA0 & STA1 go high (from 0.5 to 1 second).

I am know that the display work (I tested it with PC parallel port & PowerLCD 1.1)

I really cannot understand and I need help.
Many thanks,


Top
 Profile  
 
 Post subject:
PostPosted: Thu May 15, 2003 13:04 
Offline

Joined: Sun May 05, 2002 22:05
Posts: 2063
Location: Lappeenranta, Finland
Have you tried without status checking and just with a little delay in place of that ? How about the code, is the initialization ok and is the memory pointer set in correct place before trying to write ?


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 25 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group