hello good day, I take this opportunity to introduce diego america and you I give my first problem, I hope also to help solve yours, I have a lcd Winstar, and I see that is different from other models on pins and driver, the previous 1335 brought the thirst
In this case is the s1d13700, and sent several mail to Winstar support but no response
my doubts, the pins 17, 18,19 and 20 as the connect? ,
in the case of the 19 I would like to know if you connect to VCC or VDD,
20 is busy and I think it's OK, I'm using free bus to check the other two would not know how to put them or where,
the code I use is the one here assembly passed, I put an image down on the tab above the LCD technique, a greeting diego
(thousand pardons my English is bad)
