LCDInfo.com
http://forum.lcdinfo.com/

wg240128b with t6963c / PIC16F877
http://forum.lcdinfo.com/viewtopic.php?f=9&t=990		 Page 1 of 1
Author:  mustyberlin [ Fri Jan 14, 2005 18:12 ]
Post subject:  wg240128b with t6963c driver
hi,
ı am trying to program my wg240128b lcd, but ı can't do anything yet. ı couldnt see cursor even :oops: :oops:

please help me.. send me a small program, for example which is only "hello" displayed.. in C language..

ı use PIC16F877 device..

sorry my bad english.. help meeeeee.. pleaseee..
Author:  Syridian [ Mon Jan 17, 2005 5:29 ]
Post subject: 
Hi,

This forum is specifically provided for support of the LCDinfo program, which runs in Windows, and not for PIC based devices.

However you might be lucky and find a few people here who also play with programming the PIC Micro, and who may be able to help you. I wish you luck with your search. :)

admin edit: this post might make more sense if you know that these were originally posted here: http://forum.lcdinfo.com/viewtopic.php?t=379
Author:  Henri [ Mon Jan 17, 2005 13:17 ]
Post subject: 
Searching this forum for "t6963c" gives some hits that could be useful:

http://forum.lcdinfo.com/viewtopic.php?t=362
http://forum.lcdinfo.com/viewtopic.php?t=78

And to get more results you can do the search for "t6963c" in this forum.
Author:  mustyberlin [ Wed Jan 19, 2005 11:35 ]
Post subject: 
ı understand that;
for programming my lcd, firstly i must initialising.

1- i must determinate text address
2- i must determinate text area
3- i must determinate graphic adress
4- i must determinate graphic area
5- i must determinate screen cg mode or mode
6- i must determinate cursor pointer
and
7- i must determinate display mode....

is it enough?
Author:  Henri [ Thu Jan 20, 2005 1:57 ]
Post subject: 
Yes I think that should be enough.
Page 1 of 1 All times are UTC + 2 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/