LCDInfo.com

http://www.lcdinfo.com
It is currently Wed Jan 15, 2025 21:44

View unanswered posts | View active topics


Board index » General display discussion » Hardware

All times are UTC + 2 hours




Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
Kenneth
 Post subject: USB to Parallel
PostPosted: Mon Jul 07, 2003 17:01 
Hello everybody, I'm from HongKong.

I've recently bought a Turly 128x64 Graphic LCD and found out that is controlled by KS1080.

I can get correct display on a Dell Pentium III computer at my office. However if I hook the display on my computer at home (Epox 8RDA+), the display content is broken.

Is it possible to connect my display to a USB-LPT adaptor for printer?

http://www.bafo.com/bafo/productslists. ... uct_id=832
Top
  
 
Henri
 Post subject:
PostPosted: Mon Jul 07, 2003 20:01 
Offline

Joined: Sun May 05, 2002 22:05
Posts: 2063
Location: Lappeenranta, Finland
Usually this isn't possible. Some chips used in these converters would allow this if I understood the datasheets right but often the drivers don't. So you would probably have to write your own drivers for it. I don't personally have much experience with these converters but I don't remember anyone succesfully running lcd's with usb-lpt converters.

If you are lucky the converter from the link might work but I don't think your chances are very good.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » General display discussion » Hardware

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 14 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group