LCDInfo.com

http://www.lcdinfo.com
It is currently Sat Dec 14, 2024 5:58

All times are UTC + 2 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Nov 13, 2011 1:25 
Offline

Joined: Sun Nov 13, 2011 0:53
Posts: 2
Hi,
I got this nice VFD and I'm looking for pinout and how to make it alive. Unfortunatelly there's any tech. spec. about this model. I already found datasheets for GU256X64-332, 355, 372 but my power supply connector has different pinout:
1 - GND
2 - +another supply input ?
3 - +5V for logic
this is flipped against 332, 355, 372 and even pin 2 is evidently connected somewhere because there's PCB trace starting with T4A fuse but I don't know what voltage I should connect here. There's also small transformer on board so I gues it should have step-up for tube driver included.
When I put +5V to pin 3 it takes about 15mA and when applied to pin 2 it draws only some hundreds of uA. Does your VFDs draws more current when no control signals connected? Does it need to be turned on by some specific command? Any idea?


Top
 Profile  
 
PostPosted: Fri Jan 27, 2012 4:27 
Offline

Joined: Sun Nov 13, 2011 0:53
Posts: 2
I also asked Noritake, but they told me, that this was customer specific display so they don't give the documentation.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group