Hi again
I have now connected the display as follows:
DSUB = GFX-LCD
1 = 5
2 = 11
3 = 12
4 = 13
5 = 14
6 = 15
7 = 16
8 = 17
9 = 18
14 = 7
16 = 8
17 = 6
Also I have connected the following on the GFX-LCD:
Pin 1, FGND = 0 volt <-- not sure about this one
Pin 2, VSS = 0 volt
Pin 3, VDD = 5 volt
Pin 19, FS1 = 5/0 Volt <-- use a microswitch to alter between 5 and 0 volt, but what shall I use?
Pin 21, LED+ = 5 volt
Pin 22, LED- = 0 volt
Pin 10, RST = not connected since I do not know what to connect it to
I am now in need of help reagrding Pin 1, FGND since I am not sure how to connect this or if I shall connect it at all to 0 volt? Also need help about Pin 19, FS1 the font select pin and also Pin 10, RST, what voltage level shall I connect this to?
I have tried my connction as I described above but only get lines shown on the display. Backlight is ok and no blue smoke, yet
Please help me to finish this LCD connection.
Best regards
Robert