LCDInfo.com

http://www.lcdinfo.com
It is currently Mon Nov 25, 2024 12:04

View unanswered posts | View active topics


Board index » General display discussion » Development

All times are UTC + 2 hours




Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
kattice
PostPosted: Sat May 08, 2004 3:31 
Offline

Joined: Wed Nov 19, 2003 9:18
Posts: 4
I have CFAG12864B LCD. I'm trying to find some information regarding the intialization on LCD. The reset is pulled up to High always. Does this LCD requires special initialization?

Thanks,
Top
 Profile  
 
Henri
 Post subject:
PostPosted: Sat May 08, 2004 11:46 
Offline

Joined: Sun May 05, 2002 22:05
Posts: 2063
Location: Lappeenranta, Finland
After reset you should send the DISPLAY ON command to both chips and also set the DISPLAY START LINE. Then setting both X and Y addresses and writing data should work.

Here's the commands: http://www.skippari.net/phpBB2/viewtopi ... =2836#2836
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » General display discussion » Development

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group