LCDInfo.com

I recently purchased the above 240x128 lcd. I plan to purchase http://www.allelectronics.com/cgi-bin/c ... type=store as my neg. volt generator for contrast (-14v). The LCD has a white ccfl cathode backlight. I have a copy of Spock's T6963c wiring diagram from the LCD Studio forum (yea yea yea, I know) and I can wire the lcd, but I have a few picky questions so as I dont blow up the lcd. Pinout is :

1-Frame Gnd
2-Gnd(0v)
3-Vdd (+5v)
4-Vee (-14v)---- center wiper from pot/neg voltage
5-/WR (write enable, active low) ------------------- 16
6-/RD (read enable, active low) --------------------14
7-/CD (chip enable,clock,active low) ---------------1
8-C/D (command data) ------------------------------17
9-NC
10-/RST
11-DB0 ------------------------------------------------2
12-DB1 ------------------------------------------------3
13-DB2 ------------------------------------------------4
14-DB3 ------------------------------------------------5
15-DB4 ------------------------------------------------6
16-DB5 ------------------------------------------------7
17-DB6 ------------------------------------------------8
18-DB7 ------------------------------------------------9
19-FS (Font select) --- high 5vts/low grd for the diff text sizes 8x8 and 6x8
20-RV(invert pixel, 0=normal 1=inverted)

Questions:

1. If I dont want to put a reset switch on the LCD, what do I do with the wire from Pin 10?
2. The neg. volt generator, where do I put that? Between power connector and the 10kPot? Do I even have to have this?
3. The CCFL isnt labled +v and gnd. It has one wire from top, one from bottom and a 2 pin female connector. How do I know which one to wire +v and which one to wire gnd to?
4. Do I need any type of capicators or resistors?
5. My pinout above and Spocks t6963 diagram have different identifiers, and I need to know which identifiers on my pinout = the ones on Spocks.

If someone can please help me, I can do this. I am not an electrical expert, but I do have some electrical experience. I have a powertip 240x128 running now (thanks again Mingingbollock), but it was wired when I got it, so this will be my first wiring job and I dont want to blow it up. Thanks in advance for any help that anyone can give me.

1. /RST means active low. That means for normal operation it should be tied to +5
2. as ming said. You need it as without contrast control you'won't see anything, perhaps very vaguely.
3. as ming said.
4. advisable but not necessary
5. http://liquid-mp3.schijf.org/schematics ... -24128.gif
might be more clear.

clarification please Trev and/or Coorz:

negagive voltage. In my first post above, I found a dc-dc neg. volt generator, but it pulls 400ma, and that I think is too much. Can I use a 10k pot AS the neg. volt generator, or do I have to have a means to get the neg. voltage, then control it up/down with the pot?? Does this make sense?? Im sorry if this seems like a stupid queston, but I cannot use the one from the link above, and I do not have the electrical knowledge to make one, so I think I'm sort of stuck with how to get the -11v I need.