LCDInfo.com

http://www.lcdinfo.com
It is currently Sat Nov 16, 2024 0:13

View unanswered posts | View active topics


Board index » General display discussion » Hardware

All times are UTC + 2 hours




Post new topic Reply to topic  Page 1 of 1
  [ 6 posts ] 
  Print view Previous topic | Next topic 
Author Message
vitovitez
PostPosted: Tue May 03, 2005 13:02 
Offline

Joined: Wed Jan 05, 2005 13:57
Posts: 5
Hi,
I have one Noritake GU256x64-355. Is it compatible with the wiring and the drivers for GU256x64-372? Sorry, but no datasheet by now.
Thanks. :)
Top
 Profile  
 
Henri
 Post subject:
PostPosted: Wed May 04, 2005 0:08 
Offline

Joined: Sun May 05, 2002 22:05
Posts: 2063
Location: Lappeenranta, Finland
If I had to guess I'd say yes, the pinout and wiring and driver to use are the same. But I'm not going to give you 100% quarantee.
Top
 Profile  
 
vitovitez
 Post subject:
PostPosted: Wed May 04, 2005 9:01 
Offline

Joined: Wed Jan 05, 2005 13:57
Posts: 5
Thank you for your fast answer. I will try and keep you informed. As I have never tried to connect vfd's (or lcd's), first I will try some lcd's (I do not want to fry my supercool GU256x64-355). :D
Top
 Profile  
 
One~Zero
 Post subject:
PostPosted: Thu May 05, 2005 3:10 
Offline
User avatar

Joined: Thu Dec 09, 2004 16:01
Posts: 218
Location: NH, USA
I have a GU256x64-352 which I used the -372 scheme for and it worked. However, to make completely sure (since you don't have a pinout) you could get the data sheet for the controller ic, and work backwards from there to find out where the signals go to on the connector. It might take a little bit of time, but it would be worth it.
Top
 Profile  
 
vitovitez
 Post subject:
PostPosted: Thu May 05, 2005 9:55 
Offline

Joined: Wed Jan 05, 2005 13:57
Posts: 5
I have now the data sheet. The pin assignment is the same as in GU256x64-372. I will try this weekend (hopefully).
Thank you for your support.
Top
 Profile  
 
One~Zero
 Post subject:
PostPosted: Thu May 05, 2005 12:39 
Offline
User avatar

Joined: Thu Dec 09, 2004 16:01
Posts: 218
Location: NH, USA
Great! The VFD is a lot easier to connect than an LCD by far. :D
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 6 posts ] 

Board index » General display discussion » Hardware

All times are UTC + 2 hours


Who is online

Users browsing this forum: Bing [Bot] and 145 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group