LCDInfo.com

Hi everyone,

I am looking for a demo to run my 64128A from Displaytech with. Is there any way to just hook up the LCD to my computer (I already saw a schematic for that connection) and run a demo program?

Any answer in this regard is helpful and very appreciated.

regards

whip

What kind demo program you are looking for ?

With this shematic you can use LCDInfo and the test programs I've made. You can also use the animation progs from MarkusM.
http://www.skippari.net/lcd/ks0108.html

You should only need to wire your display following the schematic and then install DLPortIO drivers if you don't have them and run the programs.

Hello,
In the displaytech 64128a, i understand that the coulmn number increments automatically after each read/write. I have a doubt: Assuming CS1 is selected and the address is column 63 and page zero. Now after the next read/write, what is the count of the column( 64 or zero ?). likewise, what is the page count (does it again start scanning from the same page 0 or does it go to page 1?)