LCDInfo.com • View topic - Scan start-up signal <- what is it?

View unanswered posts | View active topics

Board index » General display discussion » Hardware

All times are UTC + 2 hours

Scan start-up signal <- what is it?

Page 1 of 1

[ 3 posts ]

Print view

Previous topic | Next topic

Author

Message

sonic

Post subject: Scan start-up signal <- what is it?

Posted: Thu Apr 17, 2008 6:50

Joined: Wed Apr 16, 2008 7:00
Posts: 6
Location: Novosibirsk, Russia

Hi, guys!

Could smbd explain me the meaning of pin
FRM: Scan start-up signal. :?:

As i understood at first, it's like a First Line Marker, but then i saught H (not H to L) as its level in the data****. Plz explain me how to control this pin!

Thnx :wink:

Top

Henri

Post subject:

Posted: Sat Apr 19, 2008 11:54

Joined: Sun May 05, 2002 22:05
Posts: 2063
Location: Lappeenranta, Finland

Yes FRM, scan startup and first line marker should usually refer to the same kind signal.

For the exact levels and it's timings for your exact display you should refer to your display's datasheet.

Top

sonic

Post subject:

Posted: Mon Apr 21, 2008 4:32

Joined: Wed Apr 16, 2008 7:00
Posts: 6
Location: Novosibirsk, Russia

Thnx, Henri. :wink:

But, speaking about datasheet - it's not quite clear for me

. Especially timings

Top

Page 1 of 1

[ 3 posts ]

Board index » General display discussion » Hardware

All times are UTC + 2 hours

Who is online

Users browsing this forum: No registered users and 111 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum