| LCDInfo.com http://forum.lcdinfo.com/ |
|
| starting LCD info automaticly http://forum.lcdinfo.com/viewtopic.php?f=10&t=946 |
Page 1 of 1 |
| Author: | croc4 [ Wed Dec 15, 2004 7:23 ] |
| Post subject: | starting LCD info automaticly |
If you are running MBM then you can use the "lancher" feature to start LCDinfo when windows starts, its a bit of a hack, but works well. Just set it to start at 0c, and use a sensor that does not exist (hence it reads 0c), you can also have it re-start LCDinfo if it dies. Works really well on my Win XP box. Hope this tip helps someone else, if you found this tip helpful, send a small donation to ....... 
|
|
| Author: | KrAkKeN [ Wed Dec 15, 2004 9:52 ] |
| Post subject: | |
Good idea. I'll integrate a "Start With Windows" into the IDE. |
|
| Author: | Syridian [ Sat Jan 29, 2005 11:26 ] |
| Post subject: | |
Thanks to KrAkKeN, this feature has been added to build 19. Get it Here: http://forum.lcdinfo.com/viewtopic.php?t=387 |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|